Engine

Weight (lbs): 3.89 Connecting rod assemblies include rods, crank pin, crank pin nuts, piston pin bushings and rod rollers with aluminum retainers Everything fitted with standard size rollers ready to install V-FACTOR Connecting Rod Assembly Fits: Harley...

Weight (lbs): 3.10 Use to remove the larger 2 1 - 4 " hex nut from the end of main drive gear, which secures the rear drive trans pulley. Very safe and easy to use. Just thread on the inner support collar to end of mainshaft, place the socket over the...

Weight (lbs): 0.00 Incorrect piston pin clip removal can damage the piston and incorrect installation can damage the clip. Damaged clips can come out during engine operation causing catastrophic failure. This tool is designed exclusively for the...

Weight (lbs): 2.02 Whether you want a better street cam for a stock motor, a big lift cam for a hotrod bike, or something in between then these cams are what you are looking for All of these cams are computer designed and precision ground from alloy...

Weight (lbs): 2.67 Complete with check ball and relief springs, drive gears, gaskets, keys and all necessary fittings. Chrome plated mounting hardware included. When installing these pumps on pre-1981 models, crankcase oil passage drilling is required...

Weight (lbs): 1.54 Cometic Gaskets EST (extreme sealing technology) Gasket Sets are considered the best available Head gaskets are a .040" thick 3 piece rubber coated stainless steel that measure .020" thick The primary cover gasket and gear cover gasket...

Weight (lbs): 2.64 For all length Big Twin transmission mainshafts so that you can properly torque the sprocket-pulley nut to 100-120 ft.-lbs. For use with 1 - 2 " drive ratchet, impact or torque wrench Left hand threaded collar Screws Pack of 10 on end...

Weight (lbs): 1.44 Cometic Gaskets Set includes all the necessary gaskets, O rings and seals needed when performing a complete engine rebuild. Also included are the needed chain housing gaskets and seals required when reinstalling the engine. Fits:...

Weight: 5.266 The Milwaukee-Eight® engine uses a completely unique engine case main bearing. With this in mind, Jims is proud to introduce a main bearing remover and installer designed just for the Milwaukee-Eight®. High levels of precision and accuracy...

Weight (lbs): 1.37 Includes the necessary motor gaskets and seals for a complete rebuild as shown. Fits: Harley Shovelhead FLT and FXR 5 speed 1980-Later. Includes the necessary motor gaskets and seals for a complete rebuild. Fits: Harley Shovelhead FLT...

Weight (lbs): 2.08 What was once a difficult bearing to remove can now be done with the greatest of ease. Includes instructions Removes the following bearings: HD bearing 9063 (our 67504 ) found in the outer primary cover to support the starter shaft on...

Weight (lbs): 3.40 The balancer shaft installation tool is used to align and safely install a new balancer bearing and counter balancer shaft into a Twin Cam 96" or 110" "B" Softail engine case Use our 60763 to remove the balancer shafts The right side...