JIMS MACHINING

Weight (lbs): 0.00 It's common knowledge that heat is one of an angine's worst enemies.  In developing the JIMS cylinder head cooler, JIMS had to sacrifice a few motors for the cause.  We tested...

Fuel tank removal is often required for service and diagnostics. Additionally, the tank may need to be off while the engine is running, especially for testing purposes. This presents a problem for...

Weight (lbs): 1.14 Used to line ream and finish fit gear cover cam bushing This tool pilots off of the cam bearing for a true centerline. A must have tool to do a professional job Jims Fits: Harley...

Weight (lbs): 2.95 Jims Polished Trap Door Fits: Harley Big Twin 5 speed 1987-2006 Note: Use with Part 74620 bearings & Part 72285 retaining rings Made By: JIMS MACHINING

Weight (lbs): 2.94 Jims "A Cut Above" Time Saver Transmission Kits are designed to simplify the order process when you are rebuilding your existing transmission or building one from scratch. All kits...

Weight (lbs): 7.04 Easily removes crankshaft assembly from left case on Big Twin models This tool will also separate case halves that have tight sealant bond Includes instructions Jims Fits: Harley...

Weight (lbs): 0.00 The Milwaukee-Eight has a new crankshaft oil seal that is difficult to remove without potentially damaging the crankcase bore. This tool is designed to do the job right with no...

Weight (lbs): 3.52 Safely install a new bearing using hand tools Job can be performed with the transmission still in the frame Holds bearing square to its bore, eliminating any marring of the bearing...

Weight (lbs): 2.62 These kits for the 4 speed transmission are a real time saver. All kits include the necessary gaskets, seals and small parts as pictured to rebuild transmission only. Also includes...

Weight (lbs): 3.10 Use to remove the larger 2 1 - 4 " hex nut from the end of main drive gear, which secures the rear drive trans pulley. Very safe and easy to use. Just thread on the inner support...

Weight (lbs): 2.64 For all length Big Twin transmission mainshafts so that you can properly torque the sprocket-pulley nut to 100-120 ft.-lbs. For use with 1 - 2 " drive ratchet, impact or torque...

Weight (lbs): 0.00 Peace of mind is key when it comes to building a high performance powertrain. The Compensating Sprocket Lock Kit is now ready and available for select Harley-Davidson motorcycles...