V-Factor

Weight: 0.04 If fender has a plastic plug rather than a nut insert, remove plug and use nut kit to mount solo or rear seat V-FACTOR 1-4-20 thread Seat Nut Kit Replaces HD# 59768-97

Weight: 0.01lb Made by V-FACTOR Chrome Plated Switch Hole Filler Plug (Pack of 5)

Weight: 7.18lb High quality, sturdy all metal construction Dresser style fender adds a classic touch to the 16" front wheel on Hardbody Wide Glide front ends V-FACTOR Raw Steel Unpainted Front Fender...

Features Fat Bob style in an extra large size to keep you right where you want to be, on the road. With an increased volume to 6 gallons, these steel tanks cut down on frequent fueling. ...

Weight (lbs): 19.36 5 gallon capacity Manufactured with 1982-Later factory style screw-in gas cap bungs (see the fuel section for gas caps) Will accept an FL single speedo style or low rider style...

Weight: 7.07 Footboards have steel base plates Mount to the OE brackets Available with solid mount pads or with vibration dampened pads as listed V-FACTOR 10 Inch Mount - Early Style Chrome finish...

Weight: 5.68 Footboards have steel base plates Mount to the OE brackets Available with solid mount pads or with vibration dampened pads as listed V-FACTOR 8 Inch Mount - Late Style Chrome finish...

Weight: 0.10 Stainless steel so will not rust Includes footpeg anti-rattle washers Kit is a great upgrade item for a small investment V-FACTOR Stainless Steel Kit with Machined Finish Pins Fits Male...

Weight: 0.10 Stainless steel so will not rust Includes footpeg anti-rattle washers Kit is a great upgrade item for a small investment V-FACTOR Stainless Steel Kit with Polished Pins Fits Male Mount...

Weight: 0.01 Stainless steel so will not rust Includes footpeg anti-rattle washers Kit is a great upgrade item for a small investment V-FACTOR Replacement Part C-Clip for Pin (Pack of 10) Replaces...

Weight: 4.94 Forged for strength and styled for beauty, this Jiffy stand kit includes all the necessary parts for a simple installation. Whether you depend on your Jiffy stand for the high stress...

Weight (lbs): 0.46 Fits: Harley MODELS WITH 41MM FORKS 1984-LATER Use when replacing fork tubes or tightening up those leaky legs. Includes upper and lower bushings, seal washers, seals & retaining...